Positioning The Seat; Adjusting The Motion-Control Levers; Pushing The Machine By Hand - Toro TITAN ZX4800 Operator's Manual

4. Align the bolt and anti-scalp roller in the
hole of the bracket that matched the closest
height-of-cut position
5. Insert the bolt into the bracket hole and secure
the bolt and anti-scalp roller with the flange nut
(Figure 24).

Positioning the Seat

The seat can move forward and backward
Position the seat where you have the best control of
the machine and are most comfortable.
Adjusting the
Motion-Control Levers
Adjusting the Height
Note:
Repeat the adjustment for the opposite control
lever.
The motion-control levers can be adjusted higher or
lower for maximum operator comfort
(Figure 24).
(Figure
Figure 25
(Figure
25).
Adjusting the Tilt
The motion-control levers can be tilted forward or
rearward for maximum operator comfort.
1. Loosen the upper bolt holding the control lever
to the control-arm shaft.
2. Loosen the lower bolt just enough to pivot the
control lever forward or rearward.
3. Tighten both bolts to secure the control in the
new position.
4. Repeat the adjustment for the opposite control
g027632
lever.
Pushing the Machine by
Hand
Important:
Never tow the machine because damage may
occur.
1. Park the machine on a level surface and
disengage the blade control switch.
2. Move the motion control levers outward to
neutral lock position, shut off the engine, remove
26).
the key, and wait for all moving parts to stop
before leaving the operating position. Make sure
the parking brake is disengaged.
3. Do this procedure on each side of the
machineFigure
24
Figure 26
Always push the machine by hand.
27.
g027252