Storage; Cleaning And Storage - Toro TITAN ZX4800 Operator's Manual

Storage

Cleaning and Storage

1. Disengage the blade-control switch (PTO), set
the parking brake, turn the ignition key to the
O position, and remove the key.
FF
2. Remove grass clippings, dirt, and grime from the
external parts of the entire machine, especially
the engine and hydraulic system. Clean dirt and
chaff from the outside of the engine cylinder
head fins and blower housing.
Important:
You can wash the machine with
mild detergent and water. Do not pressure
wash the machine. Avoid excessive use
of water, especially near the control panel,
engine, hydraulic pumps, and motors.
3. Check the parking brake operation; refer to
Operating the Parking Brake (page
4. Service the air cleaner; refer to
Cleaner (page 31).
5. Grease the machine; refer to
31).
6. Change the crankcase oil; refer to
Engine Oil and the Engine-Oil Filter (page
7. Check the tire pressure; refer to
Tire Pressure (page
8. Change the hydraulic fluid and filter; refer to
Changing the Hydraulic Filter and Fluid (page
40).
9. Charge the battery; refer to
(page 38).
10. Scrape any heavy buildup of grass and dirt
from the underside of the mower, then wash the
mower with a garden hose.
Note:
Run the machine with the blade-control
switch (PTO) engaged and the engine at high
idle for 2 to 5 minutes after washing.
11. Check the condition of the blades; refer to
Servicing the Cutting Blades (page
12. Prepare the machine for storage when non-use
occurs over 30 days. Prepare the machine for
storage as follows:
A. Add a petroleum based
stabilizer/conditioner to fuel in the
tank. Follow mixing instructions from
the stabilizer manufacturer. Do not use
an alcohol based stabilizer (ethanol or
methanol).
Note:
A fuel stabilizer/conditioner is most
effective when mixed with fresh fuel and
used at all times.
18).
Servicing the Air
Lubrication (page
Changing the
33).
Checking the
39).
Charging the Battery
42).
B. Run the engine to distribute conditioned fuel
through the fuel system (5 minutes).
C. Shut off the engine, allow it to cool, and
drain the fuel tank.
D. Restart the engine and run it until it stops.
E. Dispose of fuel properly. Recycle the fuel
according to local codes.
Important:
stabilizer/conditioned fuel over
90 days.
13. Check and tighten all bolts, nuts, and screws.
Repair or replace any part that is damaged.
14. Paint all scratched or bare metal surfaces. Paint
is available from your Authorized Service Dealer.
15. Store the machine in a clean, dry garage or
storage area. Remove the key from the ignition
switch and keep it out of reach of children or
other unauthorized users. Cover the machine to
protect it and keep it clean.
51
Do not store