Changing Pre-Set Options
End of Cycle Beeps
The beeps signaling the end of the cycle can be
increased or decreased.
Enter the Option Adjustment Mode.
1
Use the WASH OPTION button to select the number
2
of beeps you prefer.
Press POWER to store your selection.
3
Default Rinse Option
The normal rinse on the Regular and Heavy Duty
cycles is a Shower Rinse. When you select Softener
Rinse on these cycles the rinse changes to the
default rinse. The default rinse is the rinse option
used on the Wool, Delicate and Permanent Press
cycles. The default rinse is a spray rinse followed by
a deep rinse. However you can change the default
rinse to two deep rinses.
Enter the Option Adjustment Mode.
1
Use the SPIN SPEED buttons to select the rinse option you prefer.
2
Press POWER to store your selection.
3
Volume of Water Used in the Shower Rinse
(Regular cycle)
You can increase or decrease the volume of water
added during the shower rinse on the Regular cycle.
Enter the Option Adjustment Mode.
1
Use the WATER LEVEL buttons to select the volume
2
of water you wish to be used in the shower rinse.
Press POWER to store your selection.
3
Controlled Cold
Ecosmart™ is designed for installations that have both
hot and cold water. To ensure optimum performance
even in very cold weather, the cold water temperature
is controlled to 60˚F. However if for some reason you
do not have hot water available you may need to
change to uncontrolled cold in very cold weather.
Ecosmart™ leaves the factory with the Controlled Cold Option set. You can change this by
entering the Option Adjustment mode and by pressing the ADVANCE button once.
Number of Beeps
Light on
TIME SAVER
=
SOAK
=
SOFTENER RINSE
=
Rinse Option
Light on
1st rinse
MED spin
deep
rinse
SLOW spin
–
HOLD
spray
rinse
Shower Rinse Volume
Light on
HIGH
=
more water
MED
=
more water
LOW
=
FACTORY SETTING
Controlled Cold Options
Light color
green
=
controlled cold
amber
=
uncontrolled cold
US
15 beeps
5 beeps
no beeps
2nd rinse
deep
rinse
–
deep
rinse
29