Fisher & Paykel WA37T26GW2 Installation Instructions And User Manual page 8

Installation Instructions
Step 4
Inlet Hoses
Install hoses with the straight end (with filters)
1
fitted to the faucets.
Install elbow ends onto washing machine (inlet
2
valves are marked on the back of the machine
H=hot, C=cold). Ensure the hot is connected to the
hot, and the cold is connected to the cold.
Note:
If there is a cold water supply only, an inlet valve
cap (available from Fisher & Paykel) MUST be
connected to the hot valve. The cap prevents
water leaking from the hot valve. However, we
recommend this product is connected to both hot
and cold water.
Step 5
Leveling the Washer
Unscrew the feet so the machine is NOT sitting on
1
the corner cabinets, then fit the rubber leveling
inserts (refer to diagram 1).
Move the washer into its final position. We suggest
2
a minimum clearance of 1" (25mm) on each side for
ease of installation. (See diagram 2).
Turn on water and check hose connections for
3
leaks. Check that there are no kinks in the hoses.
It is IMPORTANT to level the washer to ensure
4
proper performance during spin.
Adjust the feet by unscrewing/screwing to make
sure the washer is level and cannot rock.
Use the walls and adjacent counter tops as a sight
5
guide to check to see if washer appears level.
Readjust the feet if necessary.
Open the lid and check the washer tub to see that
6
it sits slightly forward of centre. (See diagram 3).
8
1 Faucet 2 Washer
end of
hose
Corner cabinets
Adjustable feet
Rubber insert
Diagram 1
1" (25mm) 1" (25mm)
Diagram 2
Incorrect
adjustment
Diagram 3
end of
hose
Correct
adjustment