End Of Cycle Beeps, Re-Set Defaults, Display - Fisher & Paykel FabricSmart Installation Instructions And User Manual

Adjusting the wash settings
18
Your machine left the factory with the Machine Stops Action set as the default.
To set your machine to Automatic Recovery:
Access the SETTINGS menu (refer to page 16).
■ ■
Select OUT OF BALANCE RECOVERY.
■ ■
Select ON.
■ ■
Automatic Recovery is now activated.
■ ■
End of Cycle Beeps
The beeps signalling the end of the cycle can be set to zero, five or fifteen.
Access the SETTINGS menu (refer to page 16).
■ ■
Select END OF CYCLE BEEPS.
■ ■
Use the scroll buttons to highlight the number of beeps you would prefer, then touch
■ ■
Reset Defaults
If you wish to reset all settings back to those that are set when your machine leaves our factory:
Access the SETTINGS menu (refer to page 16).
■ ■
Select RESET DEFAULTS.
■ ■
Select YES to reset to the factory default.
■ ■
Display
Brightness
You can adjust the brightness of your display screen to suit your individual needs.
Access the SETTINGS menu (refer to page 16).
■ ■
Select DISPLAY.
■ ■
Select BRIGHTNESS.
■ ■
Use the scroll buttons to increase or decrease the screen brightness.
■ ■
Touch to confirm your selection and return to the SETTINGS menu.
■ ■
Contrast
You can adjust the contrast of your display screen to suit your individual needs.
Access the SETTINGS menu (refer to page 16).
■ ■
Select DISPLAY.
■ ■
Select CONTRAST.
■ ■
Use the scroll buttons to increase or decrease the screen contrast.
■ ■
Touch to confirm your selection and return to the SETTINGS menu.
■ ■
Press to exit the SETTINGS menu.
.