Changing Pre-Set Options; Option Adjustment Mode - Fisher & Paykel WA37T26GW2 Installation Instructions And User Manual

Changing Pre-Set Options

Option Adjustment Mode

After using your Ecosmart™ you may want to fine tune some of the options to suit your
wash needs.
You can change the following pre-set options:
the default rinse option
the amount of water used in the Shower Rinse
the number of beeps at the end of the cycle
the Out of Balance recovery routine
the fill level selected by auto water level
the controlled cold option
To make these changes it is necessary to enter the "Option Adjustment Mode".
To Enter Option Adjustment Mode
Plug the machine in, but do not press POWER.
1
Press START/PAUSE and hold down, then press
POWER.
You will hear three quick beeps and the machine
2
will show an unusual pattern of lights. In this mode
the lights are used to indicate the different options
available. The diagram on page 27 shows how the
lights relate to the options you can change.
Pages 28 – 29 explain the different options in more
detail.
Use the buttons on the panel to make your changes
3
to the pre-set options.
Press POWER to return to normal mode.
4
Your Ecosmart™ will automatically remember your
5
changes.
To make further changes, repeat the above steps.
6
26