Fisher & Paykel WA37T26GW2 Installation Instructions And User Manual page 7

Installation Instructions
Step 1
Remove Bottom Packer
Remove outer packaging.
1
Tilt the machine backwards and walk the machine off the bottom
2
packer. The plastic bottom packer can now be removed.
CAUTION!
Operating the machine when the bottom packer is
in place can result in damage to the machine.
Step 2
Removing Tub Packer and Accessories
Lift the lid and remove cardboard tub packer from
1
the top of the washer tub.
Keep the bottom packer and tub packer in case
2
they are required for future transit.
Remove hoses, accessories and installation pack.
3
The Installation Pack Contains the Following:
4 rubber inserts for the leveling feet
1 drain hose guide
Step 3
Drain Hose
Carefully pull the drain hose out from the back of the
1
washer by pulling the exposed part of the hose downwards
and then out.
The hose guide is used to guide the drain hose over the
2
tub or standpipe. It MUST be fitted to the drain hose. To
prevent siphoning the drain hose should not extend more
than ¾" (20mm) from the end of the guide.
If necessary, the drain hose can be trimmed to length.
Place the drain hose in the laundry tub or standpipe.
3
Note:
In multi-storey apartments or any upper floor installation, the machine should be installed on a
drained floor.
Check that the tub or standpipe is free from lint or other obstructions before operating the washer.
In basement installation do not exceed a standpipe height of (78").
Tub packer
Pull hose
through guide
US
¾"
(20mm)
7