End Of Cycle Beeps; Controlled Cold - Fisher & Paykel Ecosmart Clothes Washer Installation Instructions & User Manual

End of cycle beeps
Changing pre-set options
The beeps signaling the end of the cycle can be
increased or decreased.
1 Enter the Option Adjustment Mode.
2 Use the WASH OPTION button to select the number
of beeps you prefer.
s Press POWER to store your selection.
TIME SAVER = 15 beeps
SOAK = 5 beeps
SOFTENER/ = no beeps
BLEACH RINSE
Default rinse option
The normal rinse on the REGULAR and HEAVY DUTY
cycles is a SPRAY RINSE.When you select SOFTENER/ MED spin deep deep
BLEACH RINSE on these cycles the rinse changes to rinse rinse
the default rinse. The default rinse is the rinse option SLOW spin -
used on the DELICATE and PERMANENT PRESS ..........................................................................
cycles. The default rinse is a SPRgh' RINSEfollowed HOLD spray deep
by a DEEP R[NSB However, you can change the rinse rinse
default rinse to two deep rinses (as is used on the
ALLERGY cycle).
1 Enter the Option Adjustment Mode.
2 Use the SPIN SPEED buttons to select the rinse option you prefer.
s Press POWER to store your selection.
Volume of water used in the spray rinse (REGULAR cycle)
You can increase or decrease the volume of water
added dudng the rinse on the REGULAR cycle.
1 Enter the Option Adjustment Mode.
2 Use the W£FER LEVEL buttons to select the volume
of water you wish to be used in the spray rinse.
s Press POWER to store your selection.
HIGH = more water
MED = more water
LOW = FACTORY SETTING
Controlled con
Ecosmart _ is designed for installations that have
both hot and cold water.T:o ensure optimum
performance even in very cold weather, the cold
water temperature is controlled to 60_'F (15.d'C).
However, if for some reason you do not have
hot water available you may need to change to
uncontrolled cold in very cold weather.
Green = controlled cold
Amber = uncontrolled cold
Ecosmarff _ [eaves the factory with the CONTROLLED COLD Option set. You can change this by
entering the Option Adjustment mode and by pressing the ADVANCE button once.