Out Of Balance Recovery Routine; Auto Water Fill Level - Fisher & Paykel WA37T26GW2 Installation Instructions And User Manual

Changing Pre-Set Options

Out of Balance Recovery Routine

When your Ecosmart™ is spinning it can sense if the wash load is out of balance and will stop
and re-try spinning up to 3 times. If the machine still senses an unbalanced load there are two
options the machine offers.
Automatic Recovery Option:
Your Ecosmart™ will try to automatically
correct the out of balance load. It will fill with
water and agitate to redistribute the load
before trying to spin up again.
Machine Stops Option:
Your Ecosmart™ will stop, giving a short burst of beeps every five seconds and the RINSE or SPIN
light will flash. You must redistribute the load more evenly yourself. (Use this option if you wish
to conserve water.)
Enter the Option Adjustment Mode.
1
Use the REGULAR button to select the Out of Balance Recovery Option you prefer.
2
Press Power to store your selection.
3

Auto Water Fill Level

If you are not satisfied with the level that your
Ecosmart™ fills to on AUTO WATER LEVEL, you
can alter the fill level that Auto will select.
If you feel there is too much water, you can
decrease the fill level that will be selected.
Enter the Option Adjustment Mode.
1
Use the CYCLE buttons to decrease the
2
amount of water selected.
Press POWER to store your selection.
3
Note:
Heavy Duty (the default setting) provides the ideal water fill level. If you wish to change it, we
recommend changing one setting at a time until you reach the preferred level.
28
Out of Balance Recovery Options
Regular
Light on =
Light off =
Less Water
Automatic Water Level Adjustment
Adjust the water level one setting at a time.
automatic recovery
machine stops
More Water