D-Link DSL-2750U User Manual page 61

Section 3 – Web Configuration
Dynamic
RemoteI v6Addres
s
Configure 6in4 Tunnel
Choose ADVANCED > IP Tunnel > Configure 6in4 Tunnel. The page shown in
the right figure appears. In this page, you can configure IPv6 penetration through
IPv4 network. When only IPv4 access is provided by your ISP, you can access
the Internet via IPv4 and IPv6.
Click Add below the table IPTUNNEL to add tunnel items.
The following table describes the parameters of this page.
Field
Tunnel Name
Tunnel Mode
Wan Interface
Lan Interface
Click Apply to enable the settings.
Click Add below the table IPv6 Rapid Deployment to add a 6RD item, which is
a 6in4 tunnel.
The following table describes the parameters of this page.
Field
Mechanism
Dynamic
IPv4MaskLen
Prefix
BorderRelayAddre
ss
D-Link DSL-2750U User Manual
Set the obtaining mode
addresses. You can select 0 or 1.
Set the remote end IPv6 address of the tunnel.
Description
Set a tunnel name.
Select the tunnel mode as 4 in6 or 6in4.
Choose a WAN interface used for the tunnel.
Choose a LAN interface used for the tunnel.
Description
The tunnel type is 6RD, which is a 6in4 tunnel.
Set the obtaining mode of Border Relay Address.
You may choose 0 or 1.
Set the subnet mask digits of the IPv4 address of
the local WAN interface.
Set the IPv6 prefix of the 6RD tunnel.
Set the Border Relay IPv4 address at the remote
end.
of remote IPv6
59