D-Link DSL-2750U Technical Support Setup Procedure

Manually configuring bridge mode

Hide thumbs Also See for DSL-2750U:

Technical Support Setup Procedure

Manually Configuring Bridge Mode on the DSL-2750U

Step 1: Open a web browser such as Internet Explorer, Mozilla Firefox, Safari and etc. On the Address

bar type in the LAN IP Address of the DSL-2750U which is 192.168.1.1 and then press on the Enter

key on your keyboard.

Step 2: A login screen will appear, type in the User Name and the Password as "admin" all in lower

case and then type in Validate Code and then click on the Log In button.

Step 3: Click on the SETUP tab and then select on Internet Setup on the left hand side. Under the

WAN Setup, click on the button Add.

Table of Contents

Do you have a question about the DSL-2750U and is the answer not in the manual?

Page 1 Step 1: Open a web browser such as Internet Explorer, Mozilla Firefox, Safari and etc. On the Address bar type in the LAN IP Address of the DSL-2750U which is 192.168.1.1 and then press on the Enter key on your keyboard.
Page 2 Step 4: Under the ATM PVC CONFIGURATION, configure the following; VPI: Enter the VPI provided by your Internet Service Provider (ISP) VCI: Enter the VCI provided by your Internet Service Provider (ISP) Step 5: Under the CONNECTION TYPE, select Bridging on the drop down menu for Protocol and then select LLC/SNAP BRIDGING on the drop down menu for Encapsulation Mode.
Page 3 Step 6: Click on Apply button to save the settings.