D-Link DSL-2750U User Manual page 27

Section 3 – Web Configuration

Adding a WAN access in PPPoE mode:
Step 1 In Protocol drop-down list, select PPP over Ethernet (PPPoE).
Step 2 Enter the PPP Username and PPP password of PPPoE account
provided by your ISP.
Step 3 Re-enter the password for confirmation.
Step 4 In the WAN Service type drop-down list,select Internet_TR069
- Internet: the wan connection is used to access internet.
- TR069: the wan connection is used to management cpe by tr069
server and acs.
Internet_TR069: the wan connection is used to access internet and
-
management cpe by tr069 server and acs.
Step 5 Choose a connection type from the Type drop-down list. There are 3
connection types available: Always On, On Demand, and Manual.
Always On: The system automatically keeps dialing for WAN
connection once the connection is off-line.
On Demand: The system automatically dials for WAN connection
once network access request is detected. If no request is sent from the
LAN within the IdleTime, the system automatically disconnect from the
internet. You can set the Idle Time as you need.
Manual: Manually dial to connect the WAN once powering on the
Router.
Step 6 For the entries that are not mentioned above, keep them as defaults.
After setting, click Add to add the new channel.

Adding a WAN access in other modes.
To add a WAN access in other modes, select the corresponding protocol and
input the information provided by your ISP.
D-Link DSL-2750U User Manual
25