D-Link DSL-2750U User Manual page 24

Section 3 – Web Configuration

Adding a PVC in PPPoE or PPPoA mode
If the protocol is selected to PPP over Ethernet (PPPoE) or PPP over ATM
(PPPoA), the page shown as the right figure appears.
1) In Protocol drop-down list, select PPPoE (or PPPoA).
2) In Encapsulation Mode, select an option according to the information
provided by your ISP.
3) In the PPP Username and PPP Password textbox, input the Username
and password of PPPoE account provided by your ISP.
4) In the Confirm PPP Password textbox, re-enter the password.
5) In the Authentication Method drop-down list, select Auto.
6) In the WAN Service type drop-down list,select Internet_TR069
- Internet: the wan connection is used to access internet.
- TR069: the wan connection is used to management cpe by tr069
server and acs.
- Internet_TR069: the wan connection is used to access internet and
management cpe by tr069 server and acs.
7) In the Dial-up Mode drop-down list, select an option as you demand.
There are 3 modes available: Continuous, Connect On Demand, Manual.
- Always On: The system automatically keeps dialing for WAN
connection once the connection is off-line.
- On Demand: The system automatically dials for WAN connection
once network access request is detected. If no request is sent from
the LAN within the IdleTime, the system automatically disconnect
from the internet. You can set the Idle Time as you need.
- Manual: Manually dial to connect the WAN once powering on the
Router.
8) For other entries which are not mentioned above, you can keep them as
defaults.
D-Link DSL-2750U User Manual
22