Relay Test - Fetco CBS-2041e User Manual

Address Description
60 Left Brew Valve
and Flow Rate
61 Right Brew Valve
Flow Rate
62 Left Bypass Valve
and Flow Rate
63 Right Bypass
Valve Flow Rate
64 Keypad Test
65

Relay Test

Press to save the settings and exit Diagnostic mode.
Press again to exit Programming mode and return to Operating mode.
Relay Test
Tests the individual relays which control various components.
Use either batch button to actuate the relays.
To begin, you must first press the blinking Control Panel Power Switch.
Address Description
90 Left or Single Brew Valve
91 Right Brew Valve
92 Left or Single Bypass Valve
93 Right Bypass Valve
94 Hot Water Faucet
95 Fill Valve
96 Heater
97 Left or Single Brew Basket Lock
98 Right Brew Basket Lock
Press to exit Relay Test.
Press again to exit Diagnostic mode.
Press again to exit Programming mode and return to Operating mode.
Range Default
0.30 – 0.50 0.40
If #59 is GAL
or
1.13 – 1.89
1.51
If #59 is LTR
0.28 – 0.38 0.33
If #59 is GAL
or
1.05 – 1.44
1.24
If #59 is LTR
0 - 1 0
0 - 1 0
Comment
To protect the heaters, this test will work only if the tank is full.
11
Comment
Use this to compensate for minor discrepancies in
actual volume versus programmed volume. Set
lower to increase volume, higher to decrease
volume. The following formula can be used to
determine the correct setting:
ACTUAL VOLUME
X
PROGRAMMED VOLUME
Tests function of control panel switches.
0 - Skip keypad test
1 - Keypad test active
Starting at the top, press each button. Display will
read the name of the switch being pressed.
Brew switches are named S1, S2, S3, etc.
The hot water switch must be pressed last, as this
will exit the test.
0 - Skip relay test. Loop back to #50
1 – Relay test active. Go to #90
Warning: During these
tests, hot water may
be dispensed from
the va lve being tested.
CURRENT NEW
=
SETTING SETTING