Table of Contents
Advertisement
8. Click "Have Disk".
9. Select C:\AHCI\iaAHCI.inf
and then click Open.
10.
Select the appropriate
AHCI Controller of your
hardware device and
then click Next.
Appendix A NLITE and AHCI Installation Guide
Appendix A
11.
A warning message
appeared because the se-
lected SATA controller did
not match your hardware
device.
Ignore the warning and
click Yes to proceed.
12.
Click Finish.
13.
The system's settings
have been changed.
Windows XP requires that
you restart the computer.
Click Yes.
14.
Enter the BIOS utility and
modify the SATA control-
ler from IDE to AHCI. By
doing so, Windows will
work normally with the
SATA controller that is in
AHCI mode.
74
www.dfi.com
Advertisement
Table of Contents
