DFI HM103-QM87 User Manual page 32

ACPI Settings
This section is used to configure the ACPI parameters.
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Advanced
ACPI Settings
ACPI Sleep State [S3 only (Suspend to.....)]
Resume by PME [Disabled]
[Disabled]
Resume by RTC Alarm
Version 2.15.1236. Copyright (C) 2012 American Megatrends, Inc.
ACPI Sleep State
Selects the highest ACPI sleep state the system will enter when the Suspend button is
pressed.
S3(STR) Enables the Suspend to RAM function.
Resume by PME
Enables this field to use the PME signal to wake up the system.
Resume by RTC Alarm
When Enabled, the system uses the RTC to generate a wakeup event.
Chapter 3 BIOS Setup
Chapter 3
Trusted Computing
This section configures settings relevant to Trusted Computing innovations.
Select ACPI sleep state
the system will enter when
the SUSPEND button is
pressed.

Select Screen

Select Item
Enter: Select
+/ -: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Reset
ESC: Exit
32
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Advanced
Confi guration
Security Device Support [Disable]
Current Status Information
SUPPORT TURNED OFF
Version 2.15.1236. Copyright (C) 2012 American Megatrends, Inc.
Security Device Support
This field is used to enable or disable BIOS supporting for the security device. O.S will
not show the security device. TCG EFI protocol and INT1A interface will not be
available.
Enables or Disables
BIOS support for security
device. O.S will not show
Security Device. TCG
EFI protocol and INT1A
interface will not be
available.

Select Screen

Select Item
Enter: Select
+/ -:
Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save and Reset
ESC: Exit
www.dfi .com