DFI HM103-QM87 User Manual page 34

SATA Configuration
This section is used to configure the settings of SATA device.
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Advanced
SATA Controller(s) [Enabled]
SATA Mode Selection [IDE]
Serial ATA Port 0 Empty
Software Preserve Unknown
Serial ATA Port 4 ST3000DM001-1C (3000.5GB)
Software Preserve SUPPORTED
Serial ATA Port 5 ASUS DVD-E8 ATAPI
Software Preserve N/A
Version 2.15.1236. Copyright (C) 2012 American Megatrends, Inc.
SATA Controller(s)
This field is used to enable or disable the Serial ATA devices.
SATA Mode Selection
The mode selection determines how the SATA controller(s) operates.
IDE Mode
This option configures the Serial ATA drives as Parallel ATA storage devices.
AHCI Mode
This option allows the Serial ATA devices to use AHCI (Advanced Host Controller Inter-
face).
RAID Mode
This option allows the Serial ATA devices to use RAID.
Chapter 3 BIOS Setup
Chapter 3
When AHCI or RAID mode is selected in the SATA Mode Selection, it will display the following
information:
Enable or disable SATA
Device.

Select Screen

Select Item
Enter: Select
+/ -:
Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Reset
ESC: Exit
34
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Advanced
SATA Controller(s) [Enabled]
SATA Mode Selection [AHCI]
Serial ATA Port 0 Empty
Software Preserve Unknown
Port 0 [Enabled]
SATA Device Type [Hard Disk Drive]
Serial ATA Port 4 ST3000DM001-1C (3000.5GB)
Software Preserve SUPPORTED
Port 4 [Enabled]
SATA Device Type [Hard Disk Drive]
Serial ATA Port 5 ASUS DVD-E8 ATAPI
Software Preserve N/A
Port 5 [Enabled]
SATA Device Type [Hard Disk Drive]
Version 2.15.1236. Copyright (C) 2012 American Megatrends, Inc.
Port 0, Port 4 and Port 5
Enables or disables the SATA port.
SATA Device Type
Identifies the SATA port connected to Solid State Drive or Hard Disk Drive.
Determines how SATA
controller(s) operate.

Select Screen

Select Item
Enter: Select
+/ -:
Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Reset
ESC: Exit
www.dfi .com