Table of Contents
Advertisement
NC1500C
3.3
Setting the projector projection method
When the projector is shipped from the factory, the projection method is set to the front
mode (projection from the front of the screen with the projector installed on the pedestal).
It is necessary to use the remote controller for change of the projection method. Refer to the
operation manual for remote controller operation
Press the "TEST" button while holding down the "CTL" button on
[1]
the remote control panel.
The Passcode input screen appears on the LC display located on the projector's side panel.
Enter your passcode using the numeric character keys of the
[2]
remote control.
After authentication of your passcode, the Configuration menu will become active.
Use the arrow buttons "＜ / ＞" to select "Configuration".
[3]
Use the arrow buttons "＜ / ＞" to select "Installation".
[4]
Check that "Image Orient" is selected and press the ▼ button.
[5]
If "Image Orient" is not selected, press the < / > buttons to select it
Press the "< / >" buttons to select the projection method
[6]
(Image Orientation).
When shipped from the factory, it is set to [Normal-F].
- Normal-F
executed from the front of the screen.
- Normal-R
executed from the back of the screen.
Press the "ENTER" button. several times
[7]
An (*) will be put on the selected projection method (Image Orientation).
Press the "EXIT" button several times.
[8]
The projector exits the menu and goes back to the regular screen.
D-30
Front projection. With the projector installed on the pedestal, projection is
Rear projection. With the projector installed on the pedestal, projection is
3. Projector Adjustment and Connection
Advertisement
Table of Contents
