Setting Up Your Projector; Setup Procedure - NEC NC1500c Installation Manual

2.
Setting Up Your
Projector
2.1

Setup procedure

Set up the projector according to the procedure below. This chapter describes the installation
procedure until turning on of the power.
- STEP1
Projector installation (See page D-17)
- STEP 2
Connecting the power cord (See page D-18)
- STEP3
Mounting the primary lens (See page D-21)
- STEP4
Mounting the anamorphic lens motorized turret (See page D-23)
- STEP5
Installation of Small Iris (Information for Service Personnel) (See page D-25)
- STEP6
Mounting Exhaust equipment (See page D-27)
- STEP7
Mounting the lamp bulb (See page D-27)
- STEP8
Mount the following optional parts as required.
Install a touch panel (See "Touch Panel Section").
Install a multimedia switcher (See "MM2000B Section")
D-16