Side Cover Removal & Mounting - NEC NC1500c Installation Manual

NC1500C
1.3.3 Side cover removal & mounting
Side cover removal procedure
Remove the side rear cover and lens side cover by removing the hexagonal fasteners (2
places) at the bottom of covers and pulling down the covers.
Connection terminals are fastened to the side front cover by four screws. Use the following
procedures to remove this cover.
<1> Remove the four fixing screws of the
connection terminals.
<2> Open the hexagonal fasteners (2 places) at
the cover bottom.
<3> Lower the cover to remove it.
Side cover mounting procedure
Insert the covers to the top of the cover mounting positions and mount them using
hexagonal fasteners (2 places) at the bottom of covers.
For mounting the side front cover, it is necessary to fasten the connection terminal section
using the screws (4 places) that were removed. Mount the cover according to the procedure
below.
<1> Insert the claws at the cover top (2 places)
into the cover mounting holes of the
projector.
<2> Close the hexagonal fasteners (2 places) at
the cover bottom.
<3> Mount the fixing screws (4 places) of the
connection terminal section.
1. Before Setting Up Your Projector
D-15