Removing The Projector Covers - NEC NC1500c Installation Manual

NC1500C
1.3

Removing the projector covers

You can remove covers of the projector by opening hexagonal fasteners.
As shown below, a projector has 9 covers:
Name of the cover
I; Lamp change door
D; Side rear cover
C; Side front cover
Remarks for cover mounting and removal
- You cannot remove the top rear cover (B) without removing the top front cover (A) first.
- A key for the lamp doors is necessary to open and close the "A: Top surface front cover,"
"J: Lamp replacement door."
- To the top rear cover (B), the cables for rear status indicator are connected. When
removing the top rear cover, it is necessary to remove the cables for rear status indicator,
too. Refer to "1.3.1. Top rear cover removal procedure (Page.D-13)" for the procedure.
- When mounting the top front cover (A) and the top rear cover (B), connect the cables for
rear status indicator and then mount the top rear cover (B) first. Refer to "1.3.2. Top cover
mounting procedure (Page.D-14)" for the procedure.
The table below shows the covers which need to be removed at each step.
Step
Connecting the AC power cord
Connecting the Touch Panel (optional)
Mounting the Primary lens
Mounting the Turret
Mounting the Small iris
Mounting the MMS (optional)
Mounting the Exhaust equipment
D-12
B; Top rear cover
A; Top front cover
Covers (*:the covers which need to be removed at each step)
A B C D
* *
* *
1. Before Setting Up Your Projector
G; Lens side cover
E; Front cover (Top)
H; Motorized turret
mounting port
F; Front cover (Bottom)
I; Front power supply
part cover
H; Motorized turret
mounting port
E F G H1
*
*
*
*
H2
*