Turning Your Projector On - NEC NC1500c Installation Manual

NC1500C
3.2

Turning your projector on

The power to this projector is separated to the power to the projector head and power to the
lamp. To project an image, it is necessary for both power supplies to be on.
• While your projector is on, be sure to have the lens cap removed from the lens.
Note
Otherwise, the lens cap may get deformed due to a heat buildup.
• In the following instances, the power to your projector cannot be turned on even if you press the
POWER button.
• When the inside temperature is abnormally high. The protective function prevents power from
turning on. Wait some time (until the projector inside cools down) and then turn on the power.
• When the STATUS indicator is blinking without the lamp lighting up after power-on. Your projector
may be in trouble. Check the error display on the LCD screen and contact your dealer/distributor for
instructions.
• Note that the image may sometimes flicker until the lamp has stabilized (5 to 10 minutes) after
power-on. This is due to the characteristics of the lamp and is not trouble of your projector.
Preparation: Supply AC power to the projector head and to the lamp power supply unit.
Remove the lens cap.
[1]
Turn the main power switch on the
[2]
front of your projector head to on.
A buzzer will ring on the projector. The POWER indicator
and rear STATUS indicator light up orange (standby state)
Press the POWER button on the
[3]
control panel of your projector
three seconds or longer.
Your projector is turn on, and the screen glows light about
30 seconds later. The POWER indicator of the projector
lights up green.
When controlling with the remote control, press the POWER
ON button three seconds or longer.
3. Projector Adjustment and Connection
D-29