Table of Contents
Advertisement
V.25 bis Autodialer
CFICB Call failure - delayed number list is full.
DLC;xxx Call failure - number is on delayed list and the call is delayed
for xxx minutes.
Program Number Command — PRN a;nn...n
The program number command is PRN followed by the one digit
decimal address a and the number to be stored nn . . . n. Each
address can store up to 31 dial parameters. Ignored characters in the dial
number are not stored. Nine stored numbers are available at addresses
1-9.
Responses:
Same as for the CRN command, except for call progress responses.
Intermediate Call Progress Response
The following response is given only if enabled. See Option Definition
002 below.
CNX@nnnnnBPS
where nnnnn is the line speed. This connect response appears after
handshake completed, but before DSR is activated. This response is
required if the intermediate call progress option is enabled.
Dial Stored Number — CRS a
The command for dialing a stored number is CRS followed by the one
digit address a for the stored number to be dialed.
Responses:
Same as for the CRN command plus
CFINS
Call failure - number not stored.
If the number is linked with other numbers via a PRL command, failure
responses are returned as
{sep}a;{call progress messages} . . .
where a is the address dialed, followed by the separator field and call
progress messages (CFI, etc.).
11-6
V.3600
Advertisement
Table of Contents
