Break Control - \Kn - Motorola V.3600 User Manual

Break Control — \Kn
Use \Kn (n = 0-5) to indicate the action taken by the modem when a
break is encountered.
Command Operation
Break option 0
\K
Break option 1
\K1
Break option 2
\K2
Break option 3
\K3
Break option 4
\K4
Break option 5
\K5
Conditions under which breaks may occur are explained below with
descriptions of the modem's response under the different \K command
break options.
A break is sent to the serial port while the modem is in connect state
during a reliable or normal connection (no protocol, data buffered).
Command Operation
Enter command mode but do not send break to the remote
\K, \K2,
modem
\K4
Empty the data buffers and send break to the remote modem
\K1
Immediately send break to the remote modem
\K3
Send break to the remote modem in sequence with any data
\K5
received from the serial port
A break is sent to the serial port while the modem is in connect state
during a direct connection (no protocol, data not buffered).
Command
\K, \K2, \K4
\K1, \K3, \K5 Immediately send break to the remote modem
Operation
Immediately send break to the remote modem and enter
command mode when break is through
V.3600
Protocols
6-9