Terminating A Test In Progress - Q&T - Motorola V.3600 User Manual

Test Mode Operation
LDL, RDL, and RDL/TP tests are initiated after making an online data
connection in normal or direct mode only. LAL and LAL/TP are
initiated while in offline command mode. These tests can be initiated by
AT commands or by using the LCD front panel SELECT TEST menus.
Refer to Table 7-2.
Note
Bold text indicates command parameter defaults.
Table 7-2. Test Commands
Command
&T
&T1
&T3
&T4
&T5
&T6
&T7
&T8
%T
Terminating a Test in Progress — Q&T
Tests can be terminated manually or automatically. The &T command
terminates a test manually. The modem automatically goes to command
mode during LDL, LAL/TP, and RDL/TP tests. Enter the &T command
to terminate the tests. For LAL and RDL, enter the escape sequence
(+++) before the &T command to go to the command mode.
By preloading register S18 with 1 to 255, each test mode automatically
times out after the specified number of seconds and exits back to the
command mode. Loading S18 with 0 disables the auto timeout feature
and the test will run continuously until manually terminated.
For example, to run the self test analog loopback test for 30 seconds,
enter
ATS18=30&T8
The modem should respond with 000 after 30 seconds.
7-2
Operation
Terminate any test
Initiate local analog loopback test
Initiate local digital loopback test
Grant remote requested digital loopback
Deny remote requested digital loopback
Initiate remote digital loopback test
Initiate remote digital loopback with test pattern
Initiate local analog loopback test with test pattern
Transmit test pattern
V.3600