Table of Contents
Advertisement
Transmit Break / Set Break Length — \B
The \B commands tell the local modem to send a break signal to the
remote modem. In all modes except direct, S79 determines the length
of the break sent to the DTE by the modem receiving a break signal over
the link. S79 may be set directly or via \Bn where n=1-255 in 20 ms
increments. The default is 35 (700 ms).
Command
\B
\Bn
Set Auto-Reliable Buffer — \C
This determines whether or not a modem in reliable mode will buffer
data received from a modem that is not in reliable mode during the 4
seconds in which the modems try to establish a reliable link. Use these
commands when the modem is in the auto-reliable mode and is expected
to process a call from a modem not in a reliable mode.
Command
\C
\C1
V.42bis Data Compression — %C
The %C command determines application of data compression while
running LAPM protocol.
Command
%C
%C1
%C2
%C3
Operation
Sends a break signal to the remote modem (does not
modify S79)
Sets S79 to length of break desired; n=1-255 in 20 ms
increments; default= 35 (700 ms)
Operation
Disable auto reliable data buffer
Buffer data for 4 seconds or 200 characters
Operation
Data compression disabled
Enabled on transmit and receive data
Enabled on transmit data only (enhanced compression)
Enabled on receive data only (enhanced compression)
V.3600
Protocols
6-11
Advertisement
Table of Contents
