Data Link Flow Control; Break Control - Motorola V.3400 User Manual

Protocols
Data Link Flow Control \G
This flow control paces data from the remote modem to the local
modem during a normal connection. When the \G1 command is sent,
the modem uses XON/XOFF to start/stop data transmission from the
remote modem. This command is ignored during an MNP connec-
tion.
Command
\G
\G1
* default
Note
The V.3400 will transmit the XON/XOFF characters to
start/stop data transmission from the remote modem. The
V.3400 will not respond to the XON/XOFF characters. This
is to insure that a false XON/XOFF is not detected resulting
data loss.
Break Control \Kn
Use \Kn (n = 0-5) to indicate the action taken by the modem when a
break is encountered.
Command
\K
\K1
\K2
\K3
\K4
\K5
* default
Conditions under which breaks may occur are explained below with
descriptions of the modem's response under the different \K command
break options.
6-8
Disable data link flow control *
Enable data link flow control
Break option 0
Break option 1
Break option 2
Break option 3
Break option 4
Break option 5 *
Operation
Operation
V.3400