Promaster City Installation - Kargo Master 4089D Instruction Manual

ProMaster City Installation

 Remove the plugs from the
roof in the FOUR mounting
locations shown to expose the
threaded inserts. ONLY
REMOVE PLUGS FROM FOUR
INTENDED INSTALLATION
LOCATIONS.
Rear and Front Mount Locations:
 Apply sealant around the threaded inserts in the roof.
 Place the three-hole rubber pad on top of the van with the TWO OUTER HOLES over the threaded inserts.
Be sure to apply sealant thoroughly to prevent water from leaking into the cargo area.
 Bolt through the foot into the threaded inserts in the roof using M6 x 22mm hex heads, 1/4" lock
washers, and 1/4" flat washers, in the order shown.
Use
M6 x 22mm
bolts here.
 Snug tighten, but allow movement.
 Repeat for opposite side of vehicle.
For Technical Support Call: 800-343-7486, Monday-Friday, 7AM - 4 PM (PST)
Instructions – 4089D
Page 5