Document: Service Manual Description: Elliptical/Upright Bike/ Recumbent Bike Model: E7/B8/R8, 10.1’’ LCD Page: 2 of 9 Table of Contents 1. Problem Check And Solutions 1.1. No resistance during workout ----- Page 3 1.2. Console no power, no any display ----- Page 4 1.3.
Document: Service Manual Description: Elliptical/Upright Bike/ Recumbent Bike Model: E7/B8/R8, 10.1’’ LCD Page: 3 of 9 1. Problem Check And Solutions 1.1. No resistance during workout Turn off the power and wait 10 seconds then turn it on. Check console...
Document: Service Manual Description: Elliptical/Upright Bike/ Recumbent Bike Model: E7/B8/R8, 10.1’’ LCD Page: 4 of 9 1.2. Console no power, no any display Check LED1 on lower control board, Turn off the power does it lights up? Replace lower and wait 10 seconds control board.
Document: Service Manual Description: Elliptical/Upright Bike/ Recumbent Bike Model: E7/B8/R8, 10.1’’ LCD Page: 5 of 9 1.3. Touch panel no function Open the console Does lamp of Touch PCB lights up? Touch Panel oppressed, loosen the fix screw to check it.
Document: Service Manual Description: Elliptical/Upright Bike/ Recumbent Bike Model: E7/B8/R8, 10.1’’ LCD Page: 6 of 9 2. Engineering Mode 2.1. Check software version / Total used time / total used distance Press Logo 5 seconds to enter engineering mode.
Document: Service Manual Description: Elliptical/Upright Bike/ Recumbent Bike Model: E7/B8/R8, 10.1’’ LCD Page: 7 of 9 2.2. TV / DTV channel scan Press Logo 5 seconds to enter engineering mode. Press DTV Config to enter setting mode. Select country then press Auto Scan.
Document: Service Manual Description: Elliptical/Upright Bike/ Recumbent Bike Model: E7/B8/R8, 10.1’’ LCD Page: 8 of 9 2.3. Software upgrade 2.3.1. Put upgrade program in the USB storage device. ※ Please use USB 2.0 and flash memory under 16GB. ※ Put the file (MERGE.bin) at root list in USB storage device.
Page 9
Document: Service Manual Description: Elliptical/Upright Bike/ Recumbent Bike Model: E7/B8/R8, 10.1’’ LCD Page: 9 of 9 2.3.5. Press Logo 5 seconds to enter engineering mode. 2.3.6. Select model type: EPS / BS / RS or EPC / BC / RC and reboot system.
Need help?
Do you have a question about the E7 and is the answer not in the manual?
Questions and answers