Table of Contents
Advertisement
4. Operation
Note! Always read the user manual prior to use.
4.1 Start‐up
1. Start the pump by pressing "1" (On).
2. Air starts to fill up the mattress. It takes about 20 minutes to
inflate the mattress.
3. If necessary the patient can lie on the mattress even when not
inflated, in this case,
using a mattress with an air underlay, this must be inflated.
Note! We recommend that the comfort dial be set to max when inflating a deflated mattress.
2. Hang the pump at the foot end of the bed or place it on a
flat, sturdy surface.
Route the power cord so that there is no risk of it causing
someone to trip, being run over by the bed wheels or
getting crushed when the bed is raised or lowered.
If a cable holder is used (optional): open the snaps,
position the power cord in the pocket and close the
snaps.
3. Connect the air tubes from the mattress to the side of the
pump. There is an audible "click" sound when the
connectors are properly attached.
4. Check that the switch on the pump is in the "0" position
(Off). Connect the plug to an approved electrical socket.
(220 V).
the underlay will carry the load. When
8
Advertisement
Table of Contents
