Appendix A : Orbiting - Barco R9002040 Instruction Manual

Orbiting
Orbiting Speed Toggle (only in MASTER Orbiting)
Highlight 'SPEED : SLOW' with the control stick and press ENTER to
set the ORBITING SPEED to Fast.
Highlight 'SPEED : FAST' with the control stick and press ENTER to
set the ORBITING SPEED to Slow
ENTER continues to Set up Orbiting
EXIT returns to path selection menu
ADJUST returns to operational mode.
Orbiting Alignment
Preparation :
Before proceeding to the alignment of the Orbiting default settings,
be sure that the Horizontal Phase and the Raster shift are correctly
aligned with the Orbiting mode set to OFF.
This alignment must be performed in case of a multiple projector
installation with Master and Slave projectors in order to ensure a
correct operation of the Orbiting for all projectors.
Adjustment procedure Stand-Alone projector :
Highlight 'ADJUST DEVIATION' with the control stick and press
ENTER .
When adjusting the horizontal and the vertical deviation, the picture
moves in the corresponding direction, allowing the set up of the
deviation without orbiting operation.
Push the control stick to the right or backward to toggle between Hor.
and Vert. deviation andjustment.
A-2
Adjust horizontal deviation by pushing
the control stick to the left or to the right
Adjust vertical deviation by pushing
the control stick forward or backward
MASTER ORBITING
CHANGE TO MASTER
MODE : ON
SPEED : FAST
ADJUST DEVIATION
SELECT WITH
THEN <ENTERN>
DEVIATION ADJUST :
VERTICAL WITH
HORIZONTAL WITH
<EXIT> to return.
SLAVE ORBITING
CHANGE TO MASTER
ADJUST DEVIATION
SELECT WITH
THEN <ENTERN>
DEVIATION ADJUST :
VERTICAL WITH
HORIZONTAL WITH
<EXIT> to return.
5975537 RETROGRAPHICS 808s 060197
OR
OR
OR
OR
OR
OR
HORIZONTAL
ORBIT AMPL
70
VERTICAL
ORBIT AMPL
70