Connecting A S-Video Or Video Source To Port 2 - Barco R9002040 Instruction Manual

Source Connections

Connecting a S-Video or Video source to port 2.

Separate Y-luma/C-chroma signals for higher quality playback
of Super VHS signals.
Pin configuration input plug :
For S-Video :
pin 1 : earth (ground) luminance
pin 2 : earth (ground) chrominance
pin 3 : luminance (Y) signal 1Vpp ±3 dB
pin 4 : chrominance (C) signal 300 mVpp ± 3 dB
For Video :
pin 1 : earth (ground) video
pin 2 : nc
pin 3 : video signal
pin 4 : nc
Input selection
with the RCU or the local keyboard : press digit button 2
Depending on the priority setting in the 'Picture Tuning
menu', Video or S-Video can be displayed.
If the setting is not correct, start up the adjustment mode by
pushing on the ADJUST key.
Select 'Random Access' and press ENTER .
Select 'Selected source' and press ENTER .
Highlight 'Picture Tuning' and press ENTER .
Highlight Port 2 : Video and press ENTER to toggle between VIDEO
or S-VIDEO.
Press EXIT to return.
Press ADJUST to return to operational mode.
* Note: When using the Port 2 loop-through output, set the Termina-
tion Switch in the "OFF" position.
6 - 2
L
RS232 IN RS232 OUT IR REMOTE R
VCR S-VHS
ADJUSTMENT MODE
Select a path from below :
GUIDED
RANDOM ACCESS
INSTALLATION
SERVICE
IRIS
Source 02
Choose a setup pattern
Select with
from below :
then <ENTER>
<EXIT> to return.
SELECTED SOURCE
GENLOCKED PATTERN
INTERNAL # PATTERN
Select with
then <ENTER>
<EXIT> to return.
5975537 RETROGRAPHICS 808s 060197
R L
PORT 4/5
to next projector or
to a monitor
Luma/Chroma
or
Source 02
RANDOM ACCESS
ADJUSTMENT MODE
or
PICTURE TUNING
GEOMETRY
CONVERGENCE
FOCUSING
COLOR SELECT
ORBITING
CONTR. MODULATION
PICTURE TUNING
SOFT EDGE
Select with or
COLOR BALANCE
then <ENTER>
SYNC : FAST
<EXIT> to return.
PORT2 : S-VIDEO
LINE DOUBLER : ON
Select with or
<ENTER> to accept
<EXIT> to return.