Connecting A S-Video Or Video Source To Port 2 - Barco R9002129 Owner's Manual

Connecting a S-Video or Video source to port 2.

Separate Y-luma/C-chroma signals for higher quality playback of
Super VHS signals.
If a line doubler is built in :
the default position of this line doubler is ON (active), the video
input signal will be displayed as a non interlaced image (=
improved image stability).
To enable or to disable this line doubler function, enter the
adjustment mode and change the position of the ON/OFF
toggle switch (see Picture tuning in chapter 'Guided' adjust-
ment mode or 'Random access' adjustment mode).
Input selection
a. with the RCU : press digit button 2 or
b. with the local keypad.
(for access to the local keypad, see Local keypad in chapter
Location and function of controls.)
- press ADJUST key, the General access menu is displayed on the
screen.
- use the control disk to highlight 2 .
- press ENTER to select the highlighted source.
Depending on the priority setting in the 'Picture Tuning menu', Video
or S-Video can be displayed.
If the setting is not correct, start up the adjustment mode by pushing
on the ADJUST key.
Select 'Random Access' and press ENTER .
Select 'Selected source' and press ENTER .
Highlight 'Picture Tuning' and press ENTER .
Highlight 'Port 2 : Video' and press ENTER to toggle between VIDEO
and S-VIDEO.
Press EXIT to return.
Press ADJUST to return to operational mode.
5975977A BARCODATA 708 260597
COMM PORT
R G(S) B
REMOTE
RS232 IN RS232 OUT (800 peripherals) R-Y Y(S) B-Y S VIDEO
Luma/Chroma
VCR S-VHS
GENERAL ACCESS
5 6
3 4
1 2
Enter ADJUST
Select with
then <ENTER>.
<EXIT> to return
ADJUSTMENT MODE
Select a path from below :
GUIDED
RANDOM ACCESS
INSTALLATION
SERVICE
IRIS
Source 02
Choose a setup pattern
Select with or
from below :
then <ENTER>
<EXIT> to return.
SELECTED SOURCE
GENLOCKED PATTERN
INTERNAL # PATTERN
Source 02
RANDOM ACCESS
ADJUSTMENT MODE
Select with or
PICTURE TUNING
then <ENTER>
GEOMETRY
<EXIT> to return.
CONVERGENCE
FOCUSING
COLOR SELECT
ORBITING
CONTR. MODULATION
SOFT EDGE
Select with
then <ENTER>
<EXIT> to return.
Connections
S-VIDEO
Audio amplifier
SHARPNESS
TINT
COLOR
BRIGHTNESS
CONTRAST
,
or
PICTURE TUNING
or
COLOR BALANCE
SYNC : FAST
PORT2 : S-VIDEO
LINE DOUBLER : ON
Select with or
<ENTER> to accept
<EXIT> to return.
3 - 3