Summit Xgm2-2Xn Option Card - Extreme Networks Summit X450a-24tDC Hardware Installation Manual

Summit Option Cards
Figure 83: Installing the Summit XGM-2xn Option Card
Summit Option
5 Using the screws from the cover plate, secure the Summit XGM-2xn option card to the back panel of
the switch.
For information on installing or replacing the XENPAK modules in the Summit XGM-2xn option card,
refer to the Extreme Networks Pluggable Interface Modules Installation Manual.
NOTE
If you install only one XENPAK module in the Summit XGM-2xn option card, attach the supplied cover plate over
the remaining open module slot.
Be sure that the option slot always has either an installed Summit option card or a faceplate over the opening.
An open slot could divert air from the switch and cause overheating.

Summit XGM2-2xn Option Card

The Summit XGM2-2xn option card allows you to add up to two 10-gigabit XENPAK modules to the
following switches:
Summit X450a-24t switch, running ExtremeXOS 11.5.0 (or later)
●
Summit X450a-24tDC switch, running ExtremeXOS 11.5.0 (or later)
●
Summit X450a-24x switch, running ExtremeXOS 11.6.1 (or later)
●
Summit X450a-24xDC switch, running ExtremeXOS 11.6.1 (or later)
●
Summit X450a-48t switch, running ExtremeXOS 11.5.0 (or later)
●
Summit X450e-24p switch, running ExtremeXOS 11.5.0 (or later)
●
Summit X450e-48p switch, running ExtremeXOS 11.6.1 (or later)
●
The Summit XGM2-2xn option card is compatible with the following 10-gigabit XENPAK modules:
SR XENPAK module, operating in the 850 nm range
●
LR XENPAK module, operating in the 1310 nm range
●
ER XENPAK module, operating in the 1550 nm range
●
ZR XENPAK module, operating in the 1550 nm range
●
LX-4 XENPAK module, operating in the 1269-1355 nm range
●
LW XENPAK module, operating in the 1310 nm range
●
120
Card
ES4K042
Summit Family Switches Hardware Installation Guide