Figure 84
shows the Summit XGM2-2xn option card.
Figure 84: Summit XGM2-2xn Option Card
NOTE
Refer to the Extreme Networks Pluggable Interface Modules Installation Guide for more information about XENPAK
modules.
Standards-based CX-4 XENPAKs are also recognized by ExtremeXOS; contact your CX-4 module vendor to obtain
these.
Installing the Summit XGM2-2xn Option Card
CAUTION
The Summit XGM2-2xn option card is not hot-swappable. Disconnect power to the switch before installing or
removing the Summit XGM2-2xn option card. After the Summit XGM2-2xn option card is installed in a compatible
switch, XENPAK modules may be hot-swapped into and out of the option card. Use only XENPAK modules approved
by Extreme Networks.
CAUTION
Be sure that the option slot always has either an installed Summit option card or a faceplate over the opening. An
open slot could divert air from the switch and cause overheating.
To install the Summit XGM2-2xn option card:
1 Disconnect the power from the Summit switch by removing the plug from the wall outlet.
2 If a redundant power supply is in use, disconnect the power of the redundant power supply by
removing the plug from the wall outlet.
3 Attach the ESD-preventive wrist strap to your wrist and connect the metal end to the equipment
rack.
4 Remove the screws holding the filler panel over the option slot on the back of the switch
Remove the filler panel and set it aside. Save the screws for re-use.
Summit Family Switches Hardware Installation Guide
SH_010
Summit XGM2-2xn Option Card
(Figure
85).
121