Installing An Eps-160 Power Supply Into An Eps-T; Connecting The Eps-160 Power Supply To The Switch - Extreme Networks Summit X450a-24tDC Hardware Installation Manual

Figure 62: Attaching the Mounting Bracket
c Repeat steps a and
4 Slide the EPS-T into a 19-inch rack and secure it using appropriate rack-mount screws.

Installing an EPS-160 Power Supply into an EPS-T

To install an EPS-160 power supply into the EPS-T:
1 Remove the EPS-160 power supply from the packing material.
2 Remove the cover plate from an empty slot on the EPS-T.
3 Insert the power supply into the empty slot on the EPS-T.
4 Tighten the captive thumbscrews to secure the power supply to the EPS-T.
5 Connect the EPS-160 power supply to the Summit switch, following the instructions in
the EPS-160 Power Supply to the Switch" on page

Connecting the EPS-160 Power Supply to the Switch

One end of the EPS-160 cord has a keyed connector to ensure correct alignment of the connector
(Figure 63). The key is a plastic tab on the cord connector housing that fits into the EPS-160 unit to
ensure correct alignment of the connector.
Figure 63: Redundant Power Cord Connector
CAUTION
Always connect the redundant power supply cord before you attach the AC power cord to the EPS-160 power supply.
Summit Family Switches Hardware Installation Guide
Installing an EPS-160 External Power Module (with EPS-T)
ES4K026
b for the other side of the EPS-T.
97.
ES4K027
"Connecting
97