Table of Contents
Advertisement
Signamax 065-1063FSx series RS-232/422/485 to 100Base/FX Device Server / Media Converter
Use following steps set up the Device Server / Managed Media Converter:
The surface must support at least 500 gm for the Device Server / Managed Media
•
Converter.
The power outlet should be within 6 feet (1.82 meters) of the Device Server /
•
Managed Media Converter.
Visually inspect the power adapter and make sure that it is properly connected.
•
Make sure that there is proper heat dissipation from and adequate ventilation around
the Device Server / Managed Media Converter. Do not place heavy objects on the
product.
Warning:
Please exercise caution when using power tools. Also, do not
install this unit near damp or wet locations, or in close proximity to very hot
surfaces. These types of environments can have a detrimental effect on the
unit and cables.
3.4
Powering On Unit
The Device Server / Managed Media Converter uses an external power supply
providing 9~32V DC @ 0.8A from an AC power line at 50~60 Hz.
1.
Insert the power cable plug directly into the receptacle located at the back of the
device.
2.
Plug the power adapter into an available socket.
3.
Check the rear-panel LEDs as the device is powered on to verify that the Power
LED is lit. If not, check that the power cable is correctly and securely plugged in.
NOTE: The RJ-45 port accepts both 'straight-through' and 'cross-over' Ethernet cables
without the need to re-configure the port.
6
Advertisement
Table of Contents
