Configuring Port Attributes - Extreme Networks BlackDiamond 6800 Installation And User Manual

Configuring the ATM Module
Table 3-13: Changes to General Switch Commands (continued)
Command
reboot {time <date> <time> | cancel}
{slot <slot>}
clear counters
show diagnostics slot {<slot>}
run diagnostics [normal | extended] slot
<slot>

Configuring Port Attributes

The following ExtremeWare port commands are not supported for the ATM module:
•
show ports {<portlist>} collisions
•
config ports <portlist> auto off {speed [10 | 100 | 1000]}
duplex [half | full]
•
config ports <portlist> auto on
•
enable smartredundancy <portlist>
•
enable sharing <port> grouping <portlist> {port-based | address-based
| round-robin}
•
enable mirroring to <port>
•
disable learning ports <portlist>
•
config mirroring add [vlan <name> | port <port> |
vlan <name> ports <portlist>]
Except as described below, the ATM module supports the remainder of the
ExtremeWare port commands. Table 3-14 describes the changes to the ExtremeWare port
commands to support the ATM module. Commands with keywords or parameters
shown in italic typeface are existing ExtremeWare commands that have been enhanced
to support the ATM module.
3-46
Description of Change
Enhanced command: The slot <slot> option was
added to the command to make it possible to
reboot a module in a specific slot. When you
specify this option, the command applies to the
ATM module in the specified slot, rather than to
the switch.
Augmented implementation: For the ATM
module, this command clears statistics for all of
the ATM-related functions: SONET and DiffServ.
Augmented implementation: This command
displays the result of ATM module diagnostics.
Enhanced command: This command runs the
ATM module diagnostics.
Asynchronous Transfer Mode (ATM) Module Installation and User Guide