Displaying Atm Port Status Information - Extreme Networks BlackDiamond 6800 Installation And User Manual

Configuring the ATM Module
config atm delete pvc [<vpi / vci> | all] {vlan <name>} ports <portlist>
This command deletes the specified PVC configuration on the specified ATM port(s).
The optional parameter may be used to limit the scope of the command to the
vlan
specified VLAN. The PVC may still exist following command execution if multiple
VLANs have been configured to use the PVC. If the
configuration is deleted for all VLANs on the specified ATM port(s).
The command can be used to delete configuration information for the PVC identified
via the and parameters for all PVCs defined for the specified VLAN(s) or
vpi vci
port(s). The all keyword may also be used as the portlist parameter to indicate that the
command should be applied to all ATM ports. A PVC is completely deleted when there
are no longer any VLANs configured for the PVC on a given ATM port.
All associated PVCs must be deleted before an ATM port can be removed from
a VLAN.

Displaying ATM Port Status Information

To display status information for the ATM ports, use the following command:
show atm {<portlist>}
You can use the optional
the command displays; otherwise, the command displays the status information for all
ports.
By default, the command displays a summary of status information for the specified
ports.
The summary of status information includes the following information for each port:
• Values of all port configuration parameters
• Port state
• ATM statistics
The detailed status information includes the summary information plus any ATM
statistics. Table 3-1 describes the ATM receive statistics, and Table 3-2 describes the ATM
transmit statistics.
3-10
parameter to narrow the range of status information
portlist
parameter is omitted, the PVC
vlan
Asynchronous Transfer Mode (ATM) Module Installation and User Guide