Configuring And Monitoring Sonet; Sonet Parameters And Values - Extreme Networks BlackDiamond 6800 Installation And User Manual

Configuring the ATM Module

Configuring and Monitoring SONET

In addition to the ExtremeWare commands for configuring slot and port behavior that
are described in the ExtremeWare Software User Guide, this section describes the
commands used to configure and monitor SONET specific attributes on ATM ports.
This section provides information on the following topics:
• SONET Parameters and Values on page 3-14
• Commands for Configuring and Monitoring SONET Features on ATM Ports on
page 3-15
• Configuring SONET Framing on page 3-16
• Configuring SONET Clocking on page 3-16
• Configuring the Signal Fail Threshold on page 3-17
• Configuring the Signal Degrade Threshold on page 3-17
• Configuring the Section Trace Identifier on page 3-18
• Configuring the Path Trace Identifier on page 3-18
• Configuring the Signal Label on page 3-19
• Resetting SONET Configuration Parameter Values on page 3-20
• Displaying SONET Status Information on ATM ports on page 3-20
• SONET Events on ATM Ports on page 3-21

SONET Parameters and Values

This section describes the configurable SONET parameters and values. Table 3-3
describes the SONET parameters and values.
Table 3-3: SONET Parameters and Values
Parameter
Framing
Clock source
Signal Failure threshold 1
Signal Degrade threshold
J0 Section Trace byte 3
3-14
Possible Values
SONET or SDH
internal or line
10 -3 through 10 -5
2 10 -5 through 10 -9
0 through 255
Default Value
SONET
internal
10 -5
10 -6
1
Asynchronous Transfer Mode (ATM) Module Installation and User Guide