Reset Button; Console Port; Modem Port; Management Port - Extreme Networks Alpine 3804 Hardware Manual

Summit7i Switch Rear View

• Management port

For information about the LEDs and their activity on the Summit7i switch, see "Summit1i, Summit5i,
Summit7i, Summit48i, and Summit48si Switch LEDs" on page 90.

Reset Button

Use the reset button to cycle the switch down and bring the switch back up without powering off the
switch. Your saved switch configuration information is not lost; unsaved switch configurations are lost.
Use a non-conductive tool to push the reset button.

Console Port

Use the console port (9-pin, "D" type connector) to attach a terminal and access the CLI via a serial
connection. Use the console port for local management.

Modem Port

Use the modem port to connect a modem for remote access to the command line interface (CLI).
Management Port
Use the management port (10/100 Mbps Ethernet, RJ-45 connector) to plug an Ethernet cable directly
from your laptop into the switch for out-of-band management. This provides you with direct access into
the switch and allows you to view and locally manage the switch configurations.
See "Management Ports" in Chapter 1 for more information about the management port.

PCMCIA Slot

The PCMCIA slot is reserved for future use.
Summit7i Switch Rear View
Figure 24 shows the rear view for both available Summit7i switch models.
Extreme Networks Consolidated Hardware Guide 81