Installing Msm64I Modules; Msm64I Prior To Insertion In A Blackdiamond 6816 Or A Blackdiamond 6804 - Extreme Networks Alpine 3804 Hardware Manual

Installing MSM64i Modules

The BlackDiamond MSM64i module is hot-swappable. You do not need to power off the system to
insert an MSM64i module.
You need the following tools and equipment to install an MSM64i module:
• ESD-preventive wrist strap
• # 1 Phillips screwdriver
• MSM64i module
To install the MSM64i:
1 Select a slot for the module:
• Slots A through D in the BlackDiamond 6816
• Slots A through B in the BlackDiamond 6808 and BlackDiamond 6804
CAUTION
You can install MSM64i modules only in slots A through D in the BlackDiamond 6816 or slots A
through B in the BlackDiamond 6808 and BlackDiamond 6804. MSM64i modules do not fit in
numbered slots. Forceful insertion can damage the MSM64i module.
2 Attach the ESD strap that is provided to your wrist and connect the metal end to the ground
receptacle that is located on the top-left corner of the switch front panel.
3 Remove the blank faceplate from the slot to make room for the module, if applicable.
NOTE
Any unoccupied module slot in the chassis should have a blank faceplate installed to ensure
satisfactory protection from EMI and to guarantee adequate airflow through the chassis.
4 Grasp the module by its front panel with one hand, and place your other hand under the edge of the
metal panel to support the weight of the module. Check the connectors for dust and packing
materials.
CAUTION
To prevent ESD damage, handle the module by the metal panel edges only. Never touch the
components on the PCB or pins on any of the connectors.
5 For the BlackDiamond 6816 and the BlackDiamond 6804, ensure that the MSM64i is horizontal with
the module name to the left, the PCB on top, and that the ejector/injector levers are extended, as
shown in Figure 114.
Figure 114: MSM64i prior to insertion in a BlackDiamond 6816 or a BlackDiamond 6804
Extreme Networks Consolidated Hardware Guide
Installing MSM64i Modules
EW_clips2
229