Removing A Sodimm From The Msm64I Module; Removing Msm64I Modules; Adding A Sodimm To The Msm64I - Extreme Networks Alpine 3804 Hardware Manual

BlackDiamond 6800 Series Management Switch Module
Figure 116: Adding a SODIMM to the MSM64i

Removing a SODIMM from the MSM64i Module

To remove a SODIMM:
1 Attach an ESD strap to your wrist and connect the metal end to the ground receptacle that is located
on the top-left corner of the switch front panel.
2 Disengage the SODIMM by pulling out on the ejector locks that are located on either side of the
SODIMM.
3 Rotate the SODIMM out of the socket.

Removing MSM64i Modules

The BlackDiamond MSM64i module is hot-swappable. You do not need to power off the system to
remove a module.
You need the following tools and equipment to remove an MSM64i module:
• ESD-preventive wrist strap
• # 1 Phillips screwdriver
• Replacement MSM64i module
To remove an MSM64i module:
1 Attach an ESD strap to your wrist and connect the metal end to the ground receptacle that is located
on the top-left corner of the switch front panel.
2 To loosen the module, unscrew the screws with a #1 Phillips screwdriver.
232
EW_SODMs
Extreme Networks Consolidated Hardware Guide