Installing A Blackdiamond 6800 Series Power Supply - Extreme Networks Alpine 3804 Hardware Manual

Table 59: DC power supply LED activity (continued)
LED
DC out

Installing a BlackDiamond 6800 Series Power Supply

You need the following tools and equipment to install the BlackDiamond 6800 series power supplies:
• ESD-preventive wrist strap
• # 1 Phillips screwdriver
• Power supply
NOTE
Ground the rack, mount the chassis in a rack, and ground the chassis before installing any switch
components. For more information about grounding the rack, see "Protective Grounding for the Rack" on
page 52. For more information about grounding the chassis, see "Grounding the BlackDiamond 6800
Series Chassis" on page 209.
To install a power supply:
1 Attach the ESD strap that is provided to your wrist and connect the metal end to the ground
receptacle that is located on the top-left corner of the switch front panel.
2 If there is a blank faceplate covering the power supply bay, remove it and save it for future use.
3 For the BlackDiamond 6816 switch, ensure that the power supply is right side up, as shown in
Figure 102, and the locking handle is open.
For the BlackDiamond 6808 or Black Diamond 6804 switch, ensure that the power supply is right
side up, as shown in Figure 103, and the locking handle is open.
Extreme Networks Consolidated Hardware Guide
Color Indicates
Green All DC outputs are operational
Amber One or more DC outputs have failed
Off Input voltage is below 12 V
Installing a BlackDiamond 6800 Series Power Supply
215