Table of Contents
Advertisement
User manual
5.7.2 Restore Factory Config
Picture 5.7.2.1 Restore Factory Config
Users can factory reset the configurations, IP addresses and user's passwords.
If the IP address or password is forgotten, please factory reset by connecting Port 9 and Port 16. Please follow the
instruction:
Step one: Connect Port 9 and Port 16 with a RJ45 cable, the switch will reboot and factory reset.
Step Two: Several seconds after the connection, LED lights of all ports will flash for twice and finish the factory
reset. After the lights flash, please disconnect the two ports.
After factory reset, please login the management system again. The login process is the same with first login.
5.7.3 Config Management
Picture 5.7.3.1 Config Management
This management page enables configure the saving, uploading and downloading of data. users can backup and
recover the system configuration in this page.
Notes:
1. Please save the configurations, or the data will be lost after rebooting the switch.
2. All the modifications operated on configuration pages need to be saved here, or the modification will be
ineffective after system rebooting.
5.5.7.4 Reboot
Picture 5.7.4.1 Reboot
The software upgrading and some configurations can only work after rebooting the switch system, please reboot
the switch.
16
Advertisement
Table of Contents
