Loop Protection; Poe Config - 3onedata ES5026 User Manual

User manual
Picture 5.5.3.1 Configuration of Port Isolation

5.5.4 Loop Protection

Picture 5.5.4.1 Loop Detection
There are two Loop protection modes: Off and Loop Protection, the default configuration is Loop Protection mode.
When there is a loop detected, the related port will be blocked and port indicator will be red on,and the buzzer will
alarm.

5.5.5 PoE Config

Picture5. 5.5.1 PoE Config
This page allows users to configure PoE features.
Enable Bar: users can select from " Enable or Disable" in the Enable list, if "Disable" selected, the PoE power
supply will be cut off;
Priority Bar: users can select from Priority List three priority levels " Low/ Middle/High" , specific ports can be
configured as power supply priorities. The priority ports can get normal power supply when the PoE power supply
is overloaded;
Current(mA) Bar: the output currents of specific ports are showed;
Voltage(V) Bar: the output voltages of specific ports are showed;
13