Table of Contents
Advertisement
User manual
CHAPTER 5 Configure POE switch
5.1 User Login
Switch adopt Web-based interface management, the default IP is 192.168.255.1. Please make sure the IP address
of PC is in the same network segment with that of switch,or the PC can't access to manage the switch. After the
setting of IP address, please input 192.168.255.1 in the browser to access the configuration interface of switch.
The Web management interface consists of five parts, which are switch status, basic configuration, advanced
configuration, network security, system maintenance.
Picture5.1.1 Login Page
Enter user password in the above login page, the default password is admin. The system only support single user
login, other logins will be refused until the user logs out.
If IP address conflict occurs, it suggests the latest user didn't log out successfully. Please reboot the device or try
to log in again180s later.
It is advised to reset the IP address and password in first login, and make sure the switch is not configured in the
same network segment with DHCP server or Internet Gateway device.
5.2 Setup Wizard
5.2.1 Setup Wizard
Picture 5.2.1 Setup Wizard
When use the switch at first time, please follow the configuration guide and set the basic configurations. The basic
configurations include resetting IP address and password, revising the aggregation configuration and save the
configuration.
8
Advertisement
Table of Contents
