Led Indicators - ensto ECO10BTW-J Installation And Operating Instructions Manual

• Paired devices, consumption information and calendar settings are removed. The
thermostat is in floor mode.
6. Battery
6.1. The purpose of the battery is to maintain the time during power cuts. If the clock does
not keep correct time, the battery must be replaced. The battery change interval is several
years and is usage dependent.
The battery may only be replaced by a skilled or instructed person.
Disconnect the power supply before replacing the battery.
6.2. Replace the thermostat battery, figure 12.
• Remove the adjustment knob E and the cover.
• Replace the battery with the same type of battery as the original, CR1220.
• Put the cover and the adjustment knob E in place.
• Dispose of the empty battery according to local recycling guidelines.
7.

LED Indicators

LED indicator B
LED indicator C
LED indicators B
and C
8. Figures
1. Connection diagram
2. RCD operational test
3. Installing sensor conductors
4. Assembling and disassembling
5. Slide switch position
6. User interface
7. Limitation of adjustment range
8. Commissioning the Ensto Heat Control application
9. Pairing the thermostat with your mobile device
10. Ensto Heat Control Home display
11. Reset the factory settings
12. Replace the battery
Green: thermostat is on, heating is off
Red: heating is on
Blue blinking: pairing is ongoing
Blue blinking quickly: factory defaults are resetting
Blue: temperature change
Red and blue blinking alternately:
faulty sensor or floor temperature minimum and
maximum set values are too close to each other
RAK125 / 16.4.2021 23 / 44