ensto ECO10BTW-J Installation And Operating Instructions Manual page 22

• The change may be either a rise or a drop in temperature.
• The blue LED indicator C is on when the temperature change is connected.
5.6. You can carry out temperature changes in different ways depending on what kind of
a change is needed.
• "Calendar" is intended for weekly reoccuring events. For example, on weekdays you
can drop the temperature overnight and while you are away. Note! When making
settings for overnight, the night must be in two sections.
• "Boost" is intended for a temporary temperature change. For example, after a shower
you can raise the temperature in the bathroom, so that the floor will dry faster.
• "Vacation" is intended for long-term changes in temperature, e.g for a weekend
break or an annual holiday.
5.7. The "Calendar", "Boost" and "Vacation" buttons are on / off buttons. When the tem-
perature change is activated, the "Calendar" and "Vacation" buttons are green, the "Boost"
button is orange.
5.8. Press the
5.9. When the function "Adaptive temperature change" is active, the thermostat will
advance the heating, so that the desired temperature has been reached at the scheduled
time. By default, the function is on.
External Temperature Control
5.10. You can use external temperature control, if external voltage has been connected to
the thermostat.
• Disable / Enable the function from "Settings / External control".
• From "Temperature" you can set the desired temperature value. The default temper-
ature setting for external control is 10 °C.
• "Temperature change" can be either a rise or a drop in the set point temperature.
• The blue LED indicator (C) is on when the external control is in use.
• If the "External Control / Temperature" is enabled you cannot use the adjustment
knob for setting temperature.
Home Screen, figure 10
G Active device
H Set point temperature
K Actual temperature
L On / Off button
N
Enter editing mode
Resetting the Factory Settings
5.12. Reset the factory settings, figure 11.
• Remove the adjustment knob E.
• Press the Bluetooth button D on the thermostat.
• After 7 seconds, the blue LED indicator C starts to blink quickly.
22 / 44
button on home display to enter the editing mode, figure 10.
RAK125 / 16.4.2021