Baking Cycle Programming - ZANOLLI CITIZEN Series Installation, Use And Maintenance Manual

_________________________________________________________________5. WORKING
Press again to memorise the new time and day. When set, the dot
between hours and minutes begins to flash and the day display disappears.

5.4.2 Baking cycle programming

To program the baking cycle the oven must be on. Press the general
system on/off button
display and set temperature is displayed in its place.
In this condition, after selecting the desired cycle using the baking cycle
button and once the desired number for the cycle to memorise
appears on the
hold it for at least 3 seconds.
The displays show the following:
-Oven temperature and time display
-Set temperature display
-Upper element control display
-Lower element control display
-Baking cycle selection display
After 2 seconds, baking parameters can be modified according to needs.
The displays show the following:
- Oven temperature and time display
- Set temperature display
- Upper element control display
- Lower element control display
- Baking cycle selection display
Parameters that may be modified are:
1) Set temperature, by means of the
2) Values corresponding to upper and lower power, by means of the
relative controls
3) The baking Timer; this parameter can be displayed on the
display by pressing the
means of the
____________________________________________________________________________
20 CITIZEN 6 - 9/MC, CITIZEN 6+6 - 9+9/MC DIGITAL VERSION
. The message "OFF" disappears from the
display, press the timer programming button
No. of cycle
,
button, and subsequently modified by
and buttons.
and buttons;
and
Prog
Cic
Off
Off
No. of cycle
Off
Prev. set.
Prev. set.
Prev. set.